Carburetors & Accessories - Accessories

Single-Stage Power Valve

Single-Stage Power Valve Standard Flow 5.0 in. High

Single-Stage Power Valve

Single-Stage Power Valve Standard Flow 5.5 in. High

Single-Stage Power Valve

Single-Stage Power Valve Standard Flow 6.5 in. High

Single-Stage Power Valve

Single-Stage Power Valve Standard Flow 7.5 in. High

Single-Stage Power Valve

Single-Stage Power Valve Standard Flow 8.5 in. High

Umbrella Check Valve

Accelerator pump Umbrella Check Valve

MerCruiser Cable To Holley/Edelbrock/Quick fuel Carburetor Conversion Kit

This linkage adapter kit is used when converting from an original equipmentcarburetor. This kit provides the necessary components to allow you toattach factory style MerCruiser cables to any plate style mounting.

Calibration Kit for #EDE1407 & #EDE1410

Each kit includes one pair of metering rod retaining springs and assorted pairs of metering rods, metering jets, and step-up springs.

Calibration Kit for #EDE1409

Each kit includes one pair of metering rod retaining springs and assorted pairs of metering rods, metering jets, and step-up springs.

Calibration Kit for #EDE1409 on a 4.3L V6

Each kit includes one pair of metering rod retaining springs and assorted pairs of metering rods, metering jets, and step-up springs.

High Flow Needles and Seats (pair)

Off-Road Needles and Seats (pair)

Accelerator Pump Conversion Kit - 50cc

Models 2300, 4150, 4160
Instantaneous response! Pull strongly through the RPM band! A "must" for tunnel ram setups! This kit is for those who demand ultimate performance from their Holley carburetor(s). The Holley 50cc accelerator pump will substantially increase fuel capacity over the standard 30cc pump system. Eliminates flat spots off idle or at any other RPM range. This kit includes everything required for easy installation including new pump housing, arm, diaphragm, spring and longer pump housing screws.

Pair of Stainless Steel Throttle Return Springs

These stainless steel throttle return springs are universal. Can be used in numerous applications. These springs measure 5" in length and 1/2" in OD. They can be trimmed to length.

Carburetor Linkage Bushing Set

The linkage bushing set allows the attachment of a 1/4" fastener to the 1/2" diameter hole found in the throttle linkage plate of Holley four barrel carbs. Split bushing design permits simple installation and eliminates the sloppiness present when rubber bushings are used.

Accelerator Pump Plunger

Step-Up Spring Assortment (5 pair)