BBC Gen 4 Stainless Steel Pump And Bracket Mercury Sea Pump Assembly V-Belt
These are new Stainless Steel replacement sea pumps. We have configured options so that you may buy just a replacement pump only or bracket only or even an entire replacement pump assembly including the mounting bracket, V-groove pulley and mandrel. This model include a beautifully polished billet bracket and V-Belt Pulley and Mandrel.
NOTE: Billet bracket cannot be used in Circ Pump applications!
This rebuild kit is designed for use with the 625-4132 & 625-4131 GEN 7 PLUS Sea Pumps built 2020 and later. You can identify a Gen 7 Plus by the clear marking on the pump snout reading "Hardin Marine Gen 7 Plus"
Not for use on Stock pumps or older Model Gen 7 Sea pumps!
Deluxe Rebuild Kit for Gen 7 Plus Sea Pump, Mercury 350, 496 and 502 Mag
Rebuild a 625-4132 Stainless Steel Sea Pump with this kit. This deluxe kit includes wear plates, snap rings, seals, bearings, o-ring, impeller and gasket.
This rebuild kit is designed for use with the 625-4102 & 625-4101 GEN 7 Sea Pumps built 2019 and earlier.
Not for use on Stock pumps or new Model Gen 7 PLUS Sea pumps!
Deluxe Rebuild Kit for Gen 7 Sea Pump, Mercury 350, 496 and 502 Mag
Rebuild a 625-4102 Stainless Steel Sea Pump with this kit. This deluxe kit includes wear plates, snap rings, seals, bearings, o-ring, impeller and gasket.
Gen 4 Stainless Steel Pump And Bracket Mercury Sea Pump Assembly Serpentine - BBC
These are new Stainless Steel replacement sea pumps. We have configured options so that you may buy just a replacement pump only or bracket only or even an entire replacement pump assembly including the mounting bracket, Serpentine pulley and mandrel. This model include a beautifully polished billet bracket and Serpentine Pulley and Mandrel.
NOTE: Billet bracket cannot be used in Circ Pump applications!
New Gen 4 Stainless Steel Mercury Pump Assembly with Stamped Steel Bracket & Billet V-Groove Pulley - BBC Applications
These are new Stainless Steel replacement sea pumps. We have configured options so that you may buy just a replacement pump only or bracket only or even an entire replacement pump assembly including the mounting bracket, V-groove pulley and mandrel.
This kit is designed to allow venting of pressure build up inside the Sea Pump housing that could create premature failure to be released through the existing fuel pump vent system.
Note will work with all sea pumps listed below that the front housing has been tapped for 1/8 NPT:
Replacement 496 Sea Pump Axius 7" Pulley and Mandrel Kit
This billet pulley is designed as a replacement for popular MerCruiser Axius applications. Will fit stock MerCruiser or Hardin Gen 7 Pump. For 350, 496, 502 Mag with 7" diameter Axius pulley applications only. Includes mandrel and bolts.