IMCO Marine

Standard Dual Ram Power Steering for Dual Mercury 2.5 EFI

The IMCO Standard Dual Ram Power Steering System is intended for Dual Mercury 2.5 EFI powered recreational performance sport boats. Once installed, boat drivers will experience significantly more precise steering control, especially at higher speeds.

Do it yourself. Install a single ram steering system in approximately four hours or less.

Note: These kits contain non-assembled rubber hoses and brass fittings. See steering component section for stainless steel braided line options.

For parts list, and to buy replacement parts click here

Standard Dual Ram Power Steering for Mercury 300R, No Tie Bar, Outside Only

The IMCO Standard Single Ram Power Steering System is intended for Mercury 300 R powered recreational performance sport boats and used primarily in moderate water conditions. Once installed, boat drivers will experience significantly more precise steering control, especially at higher speeds.

Do it yourself. Install a single ram steering system in approximately four hours or less.

Note: These kits contain non-assembled rubber hoses and brass fittings. See steering component section for stainless steel braided line options.

Standard Single Ram Power Steering for Mercury 2.5 EFI

The IMCO Standard Single Ram Power Steering System is intended for Mercury 2.5 EFI powered recreational performance sport boats. Once installed, boat drivers will experience significantly more precise steering control, especially at higher speeds. Kit includes Tilt pin, Steering Ram, Wing Plate Outside hoses and thru hulls.

Do it yourself. Install a single ram steering system in approximately four hours or less.

For parts list, and to buy replacement parts click here

Steering Ram

2 per Gimbal Steering and Trim Assembly

Stud (7/16 x 2 1/4" SS)

4 per Upper Case Assembly (Sold Each)

Stud (7/16 x 2” S/S)

Stud (7/16 x 21/2")

4 per Upper Case Assembly (Sold Each)

Stud (7/16" x 2 3/4" S/S)

6 per Gimbal Helmet Assembly

Stud, 7/16" x 4 1/4"

6 per Gimbal Housing Assembly

Stud, 7/16" x 4 3/4"

2 per Gimbal Housing Assembly

Tab Washer (#6 Prop Shaft)

Tab Washer (17/16" Prop Shaft)

Tab Washer (Bearing Carrier)

Tab Washer (Vertical Shaft)

For 10" Diameter Aluminum Bullet, Race or "T" tanks that step down to 9" dia. (Sold Each)

Thermostat housing 3/4" NPT without bypass

These polished stainless steel thermostat housing are designed to work with our water crossovers on Chevy small block and big block.