SEI Marine Products

Fits Mercury / Mariner 4 stroke EFI
70-115hp 20"
1B366822 and below
18 Spline

Fits Mercury / Mariner 4 stroke EFI
70-115hp 25"
1B366822 and below

This driven gear bearing cup driver replaces OE # 91-33493 and is used to install the driven gear bearing race on MC-1, R, MR, and Alpha One sterndrives.

Drive Gear shim tool used in R/MR/Alpha One/Gen II upper units.
Works with all upper ratio's

Driver rod used for installing seals and bearings in Mercruiser and Mercury products.
It uses 5/8-18 thread and fits many of the bearing and seal mandrels/drivers we offer.

Fits Mercruiser Bravo One
Washer and pinion bolt included
41629A 2 & 858517A 3

Fits Mercury / Mariner 2.0 / 2.4 / 2.5 liter V6 outboards
20" Model
Eight spline upper
Non-preload pin models only

Fits Yamaha outboard
2004 to current
4 Stroke 150hp
20" models only

Driveshaft 20" Fits Yamaha Driveshaft 20-63P-45501-00-00

Fits Yamaha outboard
V6 1984 to current
90 degree engines (2.6 liter)
2 Stroke
20" models only

Driveshaft 20" Fits Yamaha Driveshaft 20-6G5-45501-01-00

Fits Mercury / Mariner 2.0 / 2.4 / 2.5 liter V6 outboards
25" Model
Eight spline upper
Non-preload pin models only

Fits Yamaha outboard
2004 to current
4 Stroke 150hp
25" models only

Driveshaft 25" Fits Yamaha Driveshaft 25-63P-45501-10-00

Fits Yamaha outboard
V6 1984 to current
90 degree engines (2.6 liter)
2 Stroke
25" models only

Replaces OE# 31-77420A 1

Replaces OE# 984462

Replaces OE# 23-32632

Replaces OE# 35983

Fits Mercruiser MR and Alpha I drives
OE# 45-42634
1982 to 1990 0D469858 and below
Driveshaft for SE106

This tool removes the Driveshaft on Johnson/Evinrude V4 and V6 engines that use a two piece drive shaft.

Replaces OE# 888909A 1

Fits Mercruiser Alpha GEN II drive only
Has a hole through the middle for oil circulation