The Xtreme Flush Mount LED’s, 5mm (3/16”) Diameter Lens. They are made of Electro-polished Stainless Steel for maximum corrosion resistance and easily mount in the dash panel through a 1/4” diameter hole and will conveniently wire up to your switch to indicate when the switch is on. They are available in Red and Blue and are wired for a 12V. system. The clean, Flush Mount LED’s mount in a Counter Sunk Hole and lay flush with the top of the Dash Panel.
These LED's are for 12 Volt systems ONLY.
5mm Flush Mount LED's Mounting & Wiring instructions:
Hole Diameter: Drill a (.25 Dia.) 1/4" Thru Hole. Use a 90 degree counter sink to (3/8" Dia.) Insert the LED thru the drilled hole and push the O-Ring onto the LED body. Then push the retaining ring onto the LED forcing it to compress the O-Ring.
Wiring: Connect the red wire to +12 volts/connect the Black wire to the (-) Ground.
Starting From:
$6.99
This Part has options, please click the button below to order.
The
Xtreme Panel Mount LED’s, 5mm (3/16”) Diameter Lens. They are made of
Electro-polished Stainless Steel for maximum corrosion resistance and
easily mount in the dash panel through a 1/4” diameter hole and will
conveniently wire up to your switch to indicate when the switch is on.
They are available in Red and Blue and are wired for a 12V. system.
These LED's are for 12 Volt systems ONLY.
5mm Panel Mount LED's Mounting & Wiring instructions:
Hole Diameter: Drill a (.25 Dia.) 1/4" Thru Hole. Insert the LED thru the drilled hole and push the O-Ring onto the LED
body. Then push the retaining ring onto the LED forcing it to compress
the O-Ring.
Wiring: Connect the red wire to +12 volts/connect the Black wire to the (-) Ground.
LED Lights for Livorsi Gauges, Wedge Style. 12.8v. LED lights outshine and outlast incandescent bulbs. NOTE: These do not work with standard DC/DCS 2-1/16" or 2-5/8" gauges. On those gauges the led is soldered to the circuit board. These lights only work on Tachs and Speedos.