Square Bore To Spread Bore Carburetor Adapter

• Spacer is 3/4" thick

This aluminum carburetor adapter allows an inexpensive method to mount a performance style square bore carburetor to an original equipment spread bore style intake manifold. Gaskets included.

Exhaust Manifold Bolt Kit (per manifold) For 455 Olds Square Exhaust Manifold

End Cap Bolt Kit (per manifold) For 455 Olds Square Exhaust Manifold

Here are our cast aluminum starter and inspection hole covers to fit most popular flywheel covers and bellhousings.

Square Flange Open Center Carburetor Base Gasket - Fits Holley 4150/4160 & Edelbrock

These are our most popular carburetor base gaskets.

Copperseal Exhaust Manifold Gaskets - Small Block Chevy Square Port- Sold in Pairs

Copperseal is the perfect for solving problems caused by uneven mating surfaces or warped flanges. Embossed raised seals fit perfectly to the exhaust ports. The resistance to high temperature and high pressure make the gaskets the ultimate choice for all applications. .04" thick.

Sold in Pairs

Copperseal Exhaust Manifold Gaskets - Big Block Chevy Square Port- Sold in Pairs

Copperseal is the perfect for solving problems caused by uneven mating surfaces or warped flanges. Embossed raised seals fit perfectly to the exhaust ports. The resistance to high temperature and high pressure make the gaskets the ultimate choice for all applications. .04" thick.

Sold in Pairs

12° Spacer Wedge Plate (Aluminum)

These carburetor spacer wedges are designed to compensate for extreme engine angles on many boats that inhibit performance. Fits square bore carburetor bolt pattern.

600 CFM, Square Flange, Electric Choke, Marine

• 5-1/8" flame arrestor flange
• metering jets: primary .098, secondary .101
• metering rods: .068 x .047
• Step-up spring: orange (5" Hg)
• 3/8" inverted flare fuel inlet fitting

For use in marine applications with Edelbrock Performer manifolds and others of similar design. Complies with U.S. Coast Guard safety standards. Cast surfaces are irradiated with Teflon coated shafts and pump arm for maximum protection. Other features include modified bowl venting, specially designed throttle shafts, accelerator pump seal, 3/8" inverted flare fuel inlet fitting,tube in air horn for fuel pump vent, 5-1/8" flame arrestor flange, universal throttle lever and a revised secondary system for improved transient performance. Comes with the following: metering jets: primary .098, secondary.101; metering rods: .068 x .047 Step-up spring: orange (5" Hg).

750 CFM, Square Flange, Electric Choke, Marine

For use in marine applications with Edelbrock Performer RPM and Torker IImanifolds and others of similar design. Complies with U.S. Coast Guard safetystandards. Cast surfaces are irradiated with Teflon coated shafts and pump armfor maximum protection. Other features include modified bowl venting, speciallydesigned throttle shafts, accelerator pump seal, 3/8" inverted flare fuel inletfitting, tube in air horn for fuel pump vent, 5-1/8" flame arrestor flange,universal throttle lever and a revised secondary system for improved transientperformance. Comes with the following: metering jets: primary .113, secondary.107; metering rods: .071 x .047 Step-up spring: orange (5" Hg).

Square Bore Carburetor Throttle Bracket

This chrome plated spread bore style throttle bracket is designed to be sandwiched between the carburetor and intake manifold while providing a secure mounting point.