CONVERSION KIT FITS:
Chevy based big block V8 engines 454-502 CID both sterndrive, inboard and V-drive. Especially designed for the low capacity raw water pumps used on sterndrive engines. Will NOT fit most engines with high mounted alternators such as late model OMC engines. Separate kits are available for those engines. Some engines have fuel line routing and fuel filter location that must be changed slightly. Heat exchanger is 4 1/8″ x 22.5″ long and fits within overall length, width, and height of most engine conversions. Heat exchanger extends from the inside of the starboard exhaust manifold towards port side clearing most high mounted power steering pumps if any. See above illustration. Plastic expansion tank mounts either on front of heat exchanger or if space is limited on vertical surface next to engine.
COOLING SYSTEM TYPE
Block only. Engine block on fresh water system. Exhaust manifolds remain on raw water system.
CONVERSION KIT
Kit includes heat exchanger, heavy duty translucent plastic expansion tank plus all other components necessary to complete conversion. Some components from engine are reused. Heat exchanger and Brackets are finished in black. Hose clamps all stainless.
HEAT EXCHANGER
Shell and tube type. Special new high capacity design. All copper alloy construction made to the highest industry standards. Heavy duty dual demountable clean out end covers. Zinc anode protection.
COOLING SYSTEM CAPACITY
Will maintain engine temperature in the 160-170oF range using 160oF thermostat, included in kit. System has capacity safety margin higher than industry standards.
HEATER SYSTEM HOOKUP
Heaters such as galley water heaters and cabin heaters are easily connected to the system by utilizing the cooling system bypass connections.
INSTALLATION TIME
Very easy installation of approximately one hour assuming new engine and normal accessibility. Allow additional time for filling and testing. Installation skills are not beyond those of most do-it-yourself boat owners. Complete illustrated installation instructions are included in kit. Ordinary hand tools used.
WARRANTY
Two year warranty. For complete details see Limited Warranty for Fresh Water Cooling Kits document enclosed with your kit and located on policies page of our website.
Note: All Monitor Products freshwater cooling kits are primer coated and finish coated in matte black.
General Maintenance and Warranty Information
You can view or download the full PDF document below:
General Manual rev01
