The VSS (Voltage Sensitive Switch) Motorized Battery Switch performs an automated paralleling function during charging, which allows two separate batteries to be charged as one.
Auto Engagement of VSS:
When the charging source is higher than 13.7VDC for
more than 5 seconds, the VSS will engage.
Auto Disengagement of VSS:
When the battery drop under 12.2VDC, VSS will be disengaged.
Same as BEP 58647
Emergency Parallel Function: The VSS Emergency Parallel Function can be operated through a remotely mounted momentary switch or button. The VSS will remain in parallel mode for 10 minutes. If after 10 minutes the voltage on either has not reached 13.0V the VSS will disengage. If the voltage reaches 13.0V on either battery the VSS will remain engaged and both batteries will continue to be charged. At any time depressing and holding momentary switch or button for 5 seconds will disengage the VSS.
Manual Override: The automatic operating of the VSS can be overridden at anytime by depressing the control knob and turning clockwise towards the "Manual On" position or anti clockwise towards the "Manual Off" position. Once the VSS attempts an automated function whilst in manual override, it determines it is in manual override (On or Off) and the LED will start flashing rapidly.
The Motorized Battery Switch has two modes of operation. Auto and Manual. There is a LED located on the battery switch to indicating Battery Switch Status.
Auto Operation:
The Battery Switch moves from a state of "Auto Off" to
"Auto On" when the remotely mounted switch is turned on. During the time that the battery switch is in "Auto On" mode, the "Auto On" LED is illuminated.
Auto operation of the battery switch is not possible whilst in manual mode. If auto operation is attempted, the LED will flash for 3 seconds then stop. Knob must
be returned to "Auto Off" before normal auto operation can continue.
Manual Operation:
The automatic operation of this battery switch can be overridden at anytime by depressing the control knob and turning clockwise towards the "Man On" position or counter clockwise towards the "Man Off" position. During the time that the Battery switch is in "Man On" mode, the "Man On" LED is illuminated.
The Motorized Battery Switch has two modes of operation. Auto and Manual. There is a LED located on the battery switch to indicating Battery Switch Status. This is a Ground activated Battery Switch, Same as 516-9805-006-1 but this
is activated by a ground, whereas the 516-9805-006-1 is activated by +12V.
Auto Operation:
The Battery Switch moves from a state of "Auto Off" to
"Auto On" when the remotely mounted switch is turned on. During the time that the battery switch is in "Auto On" mode, the "Auto On" LED is illuminated.
Auto operation of the battery switch is not possible whilst in manual mode. If auto operation is attempted, the LED will flash for 3 seconds then stop. Knob must
be returned to "Auto Off" before normal auto operation can continue.
Manual Operation:
The automatic operation of this battery switch can be overridden at anytime by depressing the control knob and turning clockwise towards the "Man On" position or counter clockwise towards the "Man Off" position. During the time that the Battery switch is in "Man On" mode, the "Man On" LED is illuminated.
Xtreme Series Valve Cover Kit, Satin, for Dry Sump with Bolt Kit
A number of companies have tried to copy this Hardin Marine cover by building sand cast copies. There's a difference if you look at their wavy, pin holed, porous covers you'll see that the Hardin Marine "XS" Xtreme cover is a beautiful die cast cover with no waves and no blemishes. So if you're looking for the best 1-piece cover this is it. This cover has been specially designed to fit marine Big Block Chevy engine with center rise exhaust. Angling one side of the cover helps to access the 2 lower center bolts while maintaining enough valve cover height to run roller rockers and stud girdles.
These valve covers come in a raw satin finish, and require preparation for powder coat or painting!