Header Accessories:
Click on the part number to check pricing or place an order.
| Electronic Water Injection Valve |
|||||||||
|
For those of you looking to upgrade from your
mechanically operated water injection systems on your headers this is
the ultimate. Buy electronically controlling water distribution
to your headers based on individual RPM settings you'll
always have a perfectly cooled header system.
|
||||||||
| Header Accessory Brass Water Injection Fittings For Headers |
|||||||||
|
These are replacement water injection fittings designed
to screw into each header tube so that you can attach the
water injection lines. Fittings are sold individually.
|
||||||||
| Header Accessory Header Water Pressure T-Valve |
|||||||||
|
This valve is a must in all water injected headers. It
is designed to eliminate water flow at an idle while
providing water flow under increased rpm's. All three connections
of the valve are -8AN.
|
||||||||
| Header Accessory Replacement T-Valve Ball & Spring |
|||||||||
|
|
These are the internal components to the t-valve
listed above. Both parts are manufactured from stainless steel.
|
||||||||
| Header Accessory Water Injection Line Restrictor Jets |
|||||||||
|
These jets are used when you just have to much water flow going to your headers. These jets will limit flow. The jets are installed by tapping the inside of the -8 header line fitting to 7/16 - 20 machine thread. Jets are sold in pairs only.
|
||||||||
| Header Accessory Hardin Marine Billet Water Control Valve |
|||||||||
|
This valve is designed to be remote mounted near the
driver for easy manual control of water to headers. The
water control valve has 4 positions: off, low, medium and high
for variable water flow to the headers. The valve is
fabricated from aluminum and has 1/4" female pipe threads on the
inlet and outlet.
|
||||||||
|
Hardin Marine |
|||||||||
 |
Transom cover plates are for
use when exhaust ports are removed to install over the transom exhaust.
The plates cover the holes left in the transom. These plates are
machined out of 6061-T6 aluminum plate - not castings. The outside
plates are 5-1/2" in diameter to cover the largest of exhaust ports. The
inner plates are 4-1/2" in diameter. The outside plate is threaded on
the back side. To install, you merely sandwich the transom of the boat
between the plates. No fiberglass work, no hassle. If you ever decide to
change your exhaust back, just take the plates off, and you're ready!
Sold as a set.
|
||||||||
|
Header Covers |
|||||||||
|
These stylish naugahyde covers are the perfect finishing touch to
your headers while your boat is either in storage or being towed. Black in color.
|
||||||||
| Header Accessory Header Bolts |
|||||||||
 |
These all stainless steel header bolts are 3/8-16 x 1"
long. They are beautifully polished to accent any header system.
|
||||||||
